（1) Before starting each shift, lubricating oil can be added to each moving part, including the manipulator, the manipulator guide, and the opening and closing mold guide. (2) The swing arm can be added for one (3-4) day. The heater's large chain and small chain can be used once a month. Frequently check whether the engine retarder and heater retarder are short of oil. The main bearing can be added every three months. (3) Check whether the moving parts are firm, whether the screws are loose and fall off, especially in the case of large impact, whether the belt drive parts are abnormal. (4) Check whether the high-pressure gas source, low-pressure gas source, power supply and water source are normal. (5) Check the emergency stop switch, safety door switch and protection device, and check whether the switch is normal. (6) Check whether the heating head enters the embryo and whether the falling part of the embryo works normally. If the insertion is not in place, an adjustable embryo pressing device nut can be used. (7) Check whether the lamp tube is damaged or damaged. Change in time. (8) Check whether the pneumatic components are leaking and whether the action is sensitive. (9) Check whether the triplet is leaking abnormally, whether it is blocked, and whether the water cup is overfilled. (10) When the solenoid valve of the automatic bottle blowing machine is abnormal, it should be cleaned in time.